Mark shared on Thingiverse:
SoaPiBarZero – a soap bar shaped enclosure for the Raspberry Pi Zero.
Includes cut outs for gpio, processor heat sink, activity led and access to the sd card.
The gpio can be accessed from above or below depending on the option selected and will fit a male or female header.
The heat sink opening will fit a standard 14x14mm heat sink.
I will upload various versions of the top and bottom parts with or without upper and lower gpio, heat sink and eyelet options so you can mix and match at will.
Every Thursday is #3dthursday here at Adafruit! The DIY 3D printing community has passion and dedication for making solid objects from digital models. Recently, we have noticed electronics projects integrated with 3D printed enclosures, brackets, and sculptures, so each Thursday we celebrate and highlight these bold pioneers!
Have you considered building a 3D project around an Arduino or other microcontroller? How about printing a bracket to mount your Raspberry Pi to the back of your HD monitor? And don’t forget the countless LED projects that are possible when you are modeling your projects in 3D!